Affiner les résultats
Affichage de 3085 - 3096 de 11924
Avis d'intention
Isolateurs de poste composite
This Standard specifies the electrical, mechanical, dimensional characteristics, test methods and acceptance criteria for composite station post insulators for outdoor service, operating at nominal voltages greater than 1000...
Avis d'intention
Norme de sécurité relative au ruban isolant de...
Please note the scope was updated as requested by the responsible SDO on March 12, 2019. 1 Scope 1.1 In the US, this standard covers the following: (a) Thermoplastic and rubber tapes for use as electrical insulation at not...
Avis d'intention
Tuyaux et raccords d'évacuation, d'égout et de...
1.1 This Standard covers Type 1 (Class 3000) and Type 2 (Class 4000) asbestos cement (AC) pipe and pipe fittings and cast iron fittings for use in drainage, waste, and vent systems inside buildings and for building drains and...
Avis d'intention
Standard for Thermoplastic Sprinkler Pipe and...
1.1 These requirements cover thermoplastic pipe and fittings for use in wet pipe sprinkler systems for fire protection service. 1.2 Thermoplastic pipe and fittings covered by these requirements are intended for use in...
Avis d'intention
Dalles en béton préfabriqué/Pavés en béton préfabriqué
This Standard specifies requirements for 1.Concrete paving slabs manufactured from hydraulic cement concrete to be used in the construction of pavement and roof coverings. It includes units with architectural finishes or...
Avis d'intention
Technologies de l’information — Fibre Channel...
This part of ISO/IEC 14165 describes extensions to the Fibre Channel signaling and physical layer requirements defined in ISO/IEC 14165-142, Fibre Channel - Physical Interfaces 2, to transport Fibre Channel over the commonly...
Avis d'intention
Technologies de l'information -- Interface de...
This part of ISO/IEC 14776 defines the physical layer of the Serial Attached SCSI (SAS) interconnect
Avis d'intention
Technologies de l'information — Architecture ...
This document specifies the characteristics of the UPnP networked device named WANConnectionDevice, version 2. This device definition is compliant with UPnP Device Architecture 1.0 [14] and UPnP Device Architecture 1.1 [15].
Avis d'intention
Technologies de l'information — Architecture ...
This document specifies the characteristics of a UPnP embedded virtual device that models a physical Wide Area Network interface on an Internet gateway. This specification describes version 2 of the device named WANDevice...
Avis d'intention
Ruban isolant en PVC
This Standard applies to polyvinyl chloride (PVC) insulating tape for use at a maximum temperature of 60, 80, 90 or 105°C, for insulating joints and splices in wires and cables having voltage ratings up to 1000 V, in...
Avis d'intention
Technologies de l’information — Architecture ...
1.1 Introduction This document defines the service DataStore:1, which identifies Version 1 of the service named DataStore. This Publicly Available Specification is applicable to Standardized DCPs of the UPnP Forum which...
Avis d'intention
Technologies de l'information - Langages de base...
ISO/IEC 13249 defines a number of packages of generic data types common to various kinds of data used in multimedia and application areas, to enable that data to be stored and manipulated in an SQL database. The package in...