Rechercher

1.1 This Standard specifies the electrical requirements for safe interconnection of inverter-based micro-distributed resource (micro-DR) systems to low-voltage systems connected to distribution systems. The output of these...

1.1 This Standard specifies the requirements for 600 V single-conductor, thermoplastic-insulated wires and cables, for use as follows: a) In Canada, in accordance with CSA C22.1, Canadian Electrical Code (CE Code), Part I; b)...

This part of ISO/IEC 11801 specifies generic cabling for use within office premises, which can comprise single or multiple buildings on a campus. It covers balanced cabling and optical fibre cabling. This document is...

CSA intends to publish a national standard that will provide the foundation for a comprehensive Canadian Paramedic Information System (CPIS). This standard will be based on frameworks, common taxonomies and designs and...

1.1 This Standard specifies energy performance and marking requirements for suspended and hugger ceiling fans intended to be connected to supply circuits not exceeding 250 V for use in residential and industrial/commercial...

1.1 This Standard specifies performance requirements for torchieres that use non-screw-in (Edison type) lamp bases and are intended primarily for residential use. 1.2 Although this Standard largely deals with fluorescent...

1.1 This Standard applies to airport series lighting cables (Type ASLC) intended for use above and below ground in dry or wet locations in accordance with the Rules of the Canadian Electrical Code, Part I, at a nominal...

1.1 This Standard specifies the requirements for 600 V single-conductor, thermoplastic-insulated wires and cables, for use as follows: a) In Canada, in accordance with CSA C22.1, Canadian Electrical Code (CE Code), Part I; b)...

1.1 This Standard specifies requirements for covered overhead distribution line wire. These conductors are intended for overhead installation as single conductors on single-phase or three-phase electrical distribution systems...

1.1 This Standard applies to oil-fired forced warm-air heating appliances for installation in mobile housing and recreational vehicles, irrespective of the heating capacity or the type of burner used. 1.2 This Standard...

1.1 General This Standard describes the performance standards, technical specifications, physical markings, and qualification tests required for breath alcohol ignition interlock devices. 1.2 Purpose This Standard identifies...

1.1 This Standard applies to the design, manufacture, installation, operation, inspection, testing, and maintenance of concrete pumps, placing booms, and delivery systems. Note: See Figures 1 to 6 for illustrations of the...