Rechercher

This International Standard applies to bare, hard-drawn, round, aluminum-clad wires of different electrical and mechanical properties, in the diameter ranges shown in table 5, for electrical purposes, before stranding. It is...

This Standard covers the electrical and mechanical characteristics of round wires of aluminium 1350-H19, having diameters of 1.25 to 6.50 mm, intended for stranding into overhead conductors to be used for electrical purposes.

This International Standard specifies the minimum design and performance requirements for an instructional seat and restraint designed for limited use by a trainer or trainee or service person inside an enclosed cab of an...

The objective of the Standard is to specify requirements for risk analysis in the medical laboratory.

This clause of Part 1 is applicable, except as follows: Addition: This Standard applies to hand-held tappers and threaders.

This clause of Part 1 is applicable except as follows: Addition: This part of IEC 62841 applies to transportable diamond drills, intended to be connected to a liquid system. Liquid system may include liquid from a pipe or...

This standard applies to newly produced gas appliance thermostats of the integral gas valve type having a maximum operating gas pressure of 1/2 psi (3.5 kPa) or electric type (see Part IV, Definitions), constructed entirely...

New standard to address the technical requirements of multi-storey, low- to high-rise buildings of volumetric modular construction, including but not limited to provisions for: • structural design • mechanical, electrical...

This part of IEC 60598 specifies requirements for floodlights for use with tungsten filament, tubular fluorescent and other discharge lamps on supply voltages not exceeding 1 000 V. It is to be read in conjunction with those...

This Standard applies to newly produced type 2 clothes dryers (see Clause 3) hereinafter referred to as dryers, constructed entirely of new, unused parts and materials for use with: a) natural gas; b) manufactured gas; c)...

This part of ISO/IEC 7816 specifies the operating conditions of an integrated circuit card that provides a USB interface. Figure 1 shows the assignment of the contact fields for a USB interface and to illustrate...

This part of ISO/IEC 14165 describes the signalling and physical requirements that may be utilized by Fibre Channel-2 (FC-2) level transport data at a rate in excess of 10 Gbit/s.