Rechercher

Scope 1.1 This Standard addresses issues related to the safety of human tissues used for transplantation. It includes quality system requirements and aspects of safety for potential and actual donors and recipients, personnel...

Scope 1.1 This Standard applies to motor-operated liquid pump units for use in nonhazardous, indoor, outdoor (exposed), and submerged locations and designed to be used in accordance with the Rules of the Canadian Electrical...

1 Scope and object 1.1 Scope of this Standard This Standard specifies requirements pertaining to the following: (a) definitions; (b) construction; (c) equipment complying with Standards; (d) safety and protection; (e)...

.1 This test method determines the wind uplift resistance of membrane-roofing systems when subjected to dynamic wind load cycles. The test methods are applicable to a) mechanically attached membrane roofing systems; and b)...

1.1 Application This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or perimeter rim joists designed to perform as beams. 1.2 Issues addressed This Standard specifies...

This part of IEC 61000-4 relates to the immunity requirements and test methods for electrical and electronic equipment, under operational conditions, with regard to: a) repetitive damped oscillatory waves occurring mainly in...

Scope Notes: 1) For requirements pertaining to loads acting on connectors, see CSA S304. 2) For requirements pertaining to installation of masonry connectors, see CSA A371. 1.1 This Standard specifies minimum requirements for...

1.1 This Standard applies to a complete cablebus system (termination to termination) and associated fittings rated at not more than 46 kV and intended for use in accordance with the Canadian Electrical Code, Part I and...

1.1 This Standard applies to solid-state lighting controls rated at 600 V and less, with or without an integral switching (disconnecting) device, designed to be used in circuits a) for the control of incandescent lamps; and b...

1.1 This Standard applies to encapsulated isolating transformers for use as a circuit continuity device, intended to be installed in airport field lighting series circuits for use in nonhazardous locations in accordance with...

1.1 General This Standard provides requirements for the design and evaluation of building components of fibre-reinforced polymers (FRP) in buildings and of building components reinforced with FRP materials. It is based on...

1.1 This Standard provides a calculation method for determining the heat loss and heat gain of buildings (as described in Clause 1.3 below) for the purpose of selecting the appropriate output capacity of a space heating...