Rechercher

1.1 This Standard defines minimum energy efficiency and performance requirements for light emitting diode (LED) lamps with an ANSI or IEC standardized base that are designed to connect to a low-voltage or branch circuit via a...

1.1 This Standard specifies energy performance and marking requirements for suspended and hugger ceiling fans intended to be connected to supply circuits not exceeding 250 V for use in residential and industrial/commercial...

1.1 This Standard applies to airport series lighting cables (Type ASLC) intended for use above and below ground in dry or wet locations in accordance with the Rules of the Canadian Electrical Code, Part I, at a nominal...

1.1 This Standard applies to indoor or outdoor, open or enclosed, shunt power capacitors and assemblies of shunt power capacitors with associated interconnections and supporting structures, for power factor improvement and...

1.1 This Standard applies to enclosed and dead-front switches for use in photovoltaic (PV) systems rated 1500 V dc maximum, 1200 A maximum. 1.2 Fusible switches for photovoltaic applications are intended for use with...

1.1 This Standard specifies requirements for covered overhead distribution line wire. These conductors are intended for overhead installation as single conductors on single-phase or three-phase electrical distribution systems...

1.1 This Standard applies to cord-connected household and commercial irons of the steam or dry type, with or without automatic temperature control, for voltages of 250 V and less, designed to be used in accordance with the...

1.1 This Standard applies to the safe storage, handling, and use of portable oxygen systems (which provide medical oxygen in high-pressure oxygen cylinders, liquid oxygen systems, and oxygen concentrators) in residential...

1 Scope 1.1 Types of valves in the scope of this Standard These requirements apply to manually operated valves for compressed natural gas. 1.2 Types of valves not in the scope of this Standard. These requirements do not apply...

Scope: This part of ISO 5349 specifies general requirements for measuring and reporting hand-transmitted vibration exposure in three orthogonal axes. It defines a frequency weighting and band-limiting filters to allow uniform...

1.1 This Standard applies to (a) heater elements for use in equipment that is intended to be connected to a supply of nominal system voltage of 600 V or less; and (b) those heater 1.2 This Standard applies to the following...

1.1 This Standard specifies requirements for 600-volt-class copper and aluminum conductor secondary and service-entrance cables intended for underground installation (a) by direct burial; or (b) in duct systems. This Standard...