Rechercher

This document specifies the electrostatic discharge (ESD) test methods necessary to evaluate electronic modules intended for vehicle use. It applies to discharges in the following cases: —     ESD in assembly; —     ESD caused by service staff; —     ESD caused by occupants. This document describes test procedures for evaluating both electronic modules on the bench and complete vehicles. This…

Scope This part of the CSA E60598 series of Standards specifies requirements for luminaires for road and street lighting, tunnel lighting, and column-integrated luminaires with a minimum total height of 2.5 m above ground level designed to be installed on branch circuits not exceeding 600 V nominal or less between conductors in accordance with CSA C22.1, Canadian Electrical Code, Part I. It…

1 Scope 1.1 General This Standard contains requirements for the material, design, manufacture, marking, and testing of serially produced, refillable Type HGV 2 containers intended only for the storage of compressed hydrogen gas for on-road vehicle operation. These containers a) are to be permanently attached to the vehicle; b) have a capacity of up to 1000 L (35.4 ft3) water capacity; and…

This document is applicable to road vehicles with automated driving functions. The document specifies the logical interface between in-vehicle environmental perception sensors (for example, radar, lidar, camera, ultrasonic) and the fusion unit which generates a surround model and interprets the scene around the vehicle based on the sensor data. The interface is described in a modular and semantic…

This document is intended to be applied to safety-related systems that include one or more electrical and/or electronic (E/E) systems and that are installed in series production motorcycles. This document does not address unique E/E systems in special vehicles such as E/E systems designed for drivers with disabilities. NOTE            The series production motorcycle is the vehicle that is…

This document specifies the dimensions and requirements for unscreened single twisted pair RF cables with a specified analogue bandwidth up to 1 GHz intended for use in road vehicle applications where the nominal system voltage is 30 V a.c. or 60 V d.c.

This document specifies the dimensions and requirements for coaxial radio frequency (RF) cables with a specified analogue bandwidth up to 6 GHz (for special cases up to 20 GHz) intended for use in road vehicle applications where the nominal system voltage is 30 V a.c. or 60 V d.c.

This document specifies the "traffic event compact" (TEC) TPEG application. The TEC application has been specifically designed to support information about traffic events (e.g. road works, traffic jams). A specific form of traffic event is local hazard warnings which, being safety-related messages, are sent with high priority to warn a driver of unexpected dangerous situations (e.g.…

This document defines the TPEG Speed information (SPI) application for reporting speed information for travellers. Speed limits are usually indicated to the driver through roadside signs. Drivers who are aware of the speed limit at all times are more likely to drive safely, which improves road safety. Most speed limit signs are static and remain unchanged for years and are thus available through…

This document specifies methods for testing the immunity of passenger cars and commercial vehicles to electromagnetic disturbances, regardless of the vehicle propulsion system (e.g. spark ignition engine, diesel engine, electric motor) using a reverberation chamber. The electromagnetic disturbances considered are limited to narrowband electromagnetic fields. While this document refers…