Building construction — Jointing products — Sealants — Determination of tensile properties at mainta...
Specifies a method for the determination of the tensile properties at maintained extension of sealants used in joints in building construction. The sealant to be tested adheres to two parallel contact surfaces of prepared test specimens which are extended to a defined width. The extension is maintained under defined conditions. Any breaks in adhesion or cohesion are recorded.
Information processing - Data interchange on 200 mm (8 in) flexible disk cartridges using two-freque...
Defines dimensional, physical and magnetic characteristics of the 200 mm (8 in) flexible disk cartridges using two-frequency recording at 13 262 ftprad on one side so as to provide physical interchangeability between data processing systems.
Road vehicles — Diesel engines — Screw-in injector, type 22
Specifies dimensional requirements for the mounting of injectors in diesel engines. The location of the fuel inlet is not defined since it varies with the particular application. Applies to the complete screw-in injector of type 22. A figure illustrates the shape and reference quantities of concern.
Rolling bearings — Instrument precision bearings
Specifies the characteristics that define instrument precision rolling bearings, their types, boundary dimensions, tolerances and internal clearance, classifications used for selective assembly, torque definitions and test conditions, and limitations of bearing yield rates.
Basic quantities in cutting and grinding — Part 3: Geometric and kinematic quantities in cutting
This part of ISO 3002 deals specially with the geometric and kinematic quantities in cutting. Is generally applicable to all machining operations, including grinding. Defines feed , cutting edge and related quantities, engagment, cut and pass and their dimensions. and the material removal rate respectively. Contains terms in English, French, Russian as well as equivalent terms in German, Italian…
Building construction — Modular coordination — System of preferred numbers defining multimodular siz...
Establishes a system of preference for numbers for use as the numerical factor in multimodular sizes especially for horizontal dimensions in building, and guidance for its use. Is applicable to buildings of all types designed in accordance with the principles and rules of modular coordination as laid down in ISO 2848.
Lifts and service lifts (USA : elevators and dumbwaiters) — Part 6: Passenger lifts to be installed ...
Lays down the appropriate rules applying to standardized lifts of class I and permitting the number of lifts and their main characteristics to be defined at the very beginning of building design. Three quality levels are specified for the lift service. Part 1 covers the lifts of classes I, II and III, part 2 the lifts of class IV, part 3 service lifts of class V and part 5 control devices,…
Defines terms relating to gas analysis, in English and in French. The vocabulary is restricted to the presentation of the methods most currently used in gas analysis. Alphabetical indexes in english and french languages are also given.
Earth-moving machinery — Operation and maintenance — Training of mechanics
Describes the training of mechanics appropriate for earth-moving machinery. Does not specify any procedure for assessing proficiency or competence, since these factors are usually covered by local and national practices and regulations. Applies to all earth-moving machinery as defined in ISO 6165.
Paints and varnishes — Indentation test (spherical or pyramidal)
The test method is applicable on a single or multi-coat system. The result is expressed as the depth of indentation produced when an indentor of specified or between the interested parties agreed size and shape is applied to the coating under defined conditions. The method is applicable if the identation does not exceed approximately 10 % of the total coating thickness. The indentation apparatus…