Rechercher

1.1 General This Standard provides requirements for the design and evaluation of building components of fibre-reinforced polymers (FRP) in buildings and of building components reinforced with FRP materials. It is based on...

1.1 This Standard provides a calculation method for determining the heat loss and heat gain of buildings (as described in Clause 1.3 below) for the purpose of selecting the appropriate output capacity of a space heating...

1.1 La présente norme énonce les exigences minimales relatives aux tuyaux flexibles et tuyaux flexibles à raccords, y compris les tuyaux flexibles et tuyaux flexibles à raccords de récupération de la vapeur, à utiliser dans...

1.1 These requirements cover bare and covered ferrules intended for field wiring and factory wiring for use in accordance with the National Electrical Code, ANSI/NFPA-70 and Canadian Electrical Code, Part I, CSA C22.1. 1.2...

Note 1: The standard development activity for this NOI was updated by the responsible SDO on April 20, 2021. Note 2 : Le champ de cet avis d’intention (publié pour la première fois le 16 mars 2021) a été mis à jour par l’OEN...

This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of electric HEAT PUMPS, including SANITARY HOT WATER HEAT PUMPS, AIR CONDITIONERS, and DEHUMIDIFIERS incorporating motor...

1.1 Les présentes exigences portent sur les conduits de graisse et les ensembles conduit de graisse préfabriqués pouvant être installés à la place des conduits de graisse en acier au carbone de 1,37 mm entièrement soudé ou en...

1.1 These requirements cover vault doors and vault modular panels (for use in the construction of vault floors, walls and ceilings), of the type intended for use in financial institutions, commercial, industrial and...

1.1 This Standard applies to the design of aluminum alloy members and assemblies intended to carry a known load. 1.2 This Standard specifies requirements for the design of members to meet the requirements of the National...

1.1 This standard applies to pin and sleeve type plugs, receptacles, power inlets, and connectors, rated up to 800 amperes and up to 600 volts ac or dc, and which may include up to eight pilot contacts. These devices are...

1.1 This Standard applies to portable type gas water heaters (herein after referred to as appliance or water heater) for use with propane, butane, or liquefied petroleum gases and mixtures thereof having: a) a regulated...

SCOPE This Standard covers minimum requirements for nonmetallic tanks of the atmospheric storage type from 227 to 2500 L intended primarily for the storage and supply of heating fuel for oil burning equipment, or alternately...