Rechercher

1. SCOPE 1.1 This Standard specifies the requirements for the installation of thermal insulating bead-applied two-component polyurethane foam used as an insulating air sealant (including a component within an air barrier system) for both building and non-building applications. The material is installed as air sealant foam in holes, cracks or gaps. 1.2 These are requirements for both the…

ISO 14954:2005 normalizes the exchange of mathematical models between spacecraft contractors (SCC) and launch service providers (LSP). It identifies standard methods for modelling the dynamic behaviour of both launch vehicles (LV) and spacecraft (SC) particularly when they are coupled prior to launch and during the early moments of the launch phase. In standard mode, the delivered models…

Establishes a standard procedure for determining the preconditioning of non-hermetic surface mount devices (SMDs) prior to reliability testing. The test method defines the preconditioning flow for non-hermetic solid-state SMDs representative of a typical industry multiple solder reflow operation. These SMDs should be subjected to the appropriate preconditioning sequence described in this standard…

ISO 9554:2005 specifies the general characteristics of fibre ropes and their constituent materials. ISO 9554:2004 is intended to be used in conjunction with the standards for the individual types of fibre rope, which cover the physical properties and specific requirements for that particular product type. ISO 9554:2005 also gives some information on the use of fibre ropes and also on their…

ISO/TS 10303-1164:2004 specifies the application module for Product as individual. The following are within the scope of ISO/TS 10303-1164:2004: representation of the information to identify an actual product; representation of the…

This National Standard of Canada is equivalent to International Standard ISO/IEC TR 18057:2004. 1 Scope Services for Computer Supported Telecommunications Applications are defined by Standard ECMA-269 and the XML Protocol for those services are defined by Standard ECMA-323. In many cases, applications require only a small subset of the features standardized in CSTA. In a voice browser…

This National Standard of Canada is equivalent to International Standard ISO 2061:1995. 1. Scope 1.1 This International Standard specifies a method for the determination of the direction of twist in yarns, the amount of twist, in terms of turns per unit length, and the change in length on untwisting, by the direct counting method. 1.2 This International Standard is applicable to: a) single…

This National Standard of Canada is equivalent to International Standard ISO/IEC 17462:2000. 1 Scope This International Standard specifies the physical and magnetic characteristics of a 3,81 mm wide magnetic tape cartridge to enable physical interchangeability of such cartridges between drives. It also specifies the quality of the recorded signals, the recording method and the recorded format…

This National Standard of Canada is equivalent to International Standard ISO/IEC 7810:2003. 1 Scope This International Standard is one of a series of standards describing the characteristics for identification cards as defined in the definitions clause and the use of such cards for international interchange. This International Standard specifies the physical characteristics of…

ISO 1514:2004 specifies several types of standard panel and describes procedures for their preparation prior to painting. These standard panels are for use in general methods of test for paints, varnishes and related products.