Rechercher

This National Standard of Canada is equivalent to International Standard ISO/IEC 8484:2007. Scope This International Standard specifies the characteristics and location of a magnetic stripe on a savingsbook as defined in Clause 4 and the use of such savingsbooks for international interchange. Compatibility with international interchange systems is provided through the requirements of this…

ISO 4521:2008 specifies requirements for electroplated silver and silver alloy coatings for electrical, electronic and other engineering applications, including test methods. Engineering applications are defined as those in which the coating essentially serves a non-decorative purpose. Although ISO 4521:2008 does not specify the condition, finish or surface roughness of the basis material prior…

1. SCOPE 1.1 This standard establishes the minimum performance requirements for reduced recoil rope intended for use in, but not limited to, marine applications, primarily ship and boat handling. 1.2 Quantities and dimensions in this standard are given in metric units with yard/pound equivalents, mostly obtained through soft conversion, given in parentheses. The metric units shall be regarded as…

1. PURPOSE AND SCOPE 1.1 This method determines the flame spread properties of a textile or product when a specimen is supported at an angle of 45º and a flame is applied to its upper surface for 1 s. 1.2 The testing and evaluation of a product against this method may require the use of materials and/or equipment that could be hazardous. This document does not purport to address all the…

ISO 12176-2:2008 specifies performance requirements for electrofusion control units for use with polyethylene (PE) electrofusion fittings for the supply of gaseous fuels or for the conveyance of water for human consumption, including raw water prior to treatment and for the conveyance of water for general purpose or other fluids. The control units are divided into three input voltage classes:…

ISO 5269-3:2008 specifies two procedures for preparing a closed water system which is in retention equilibrium, to be used for the preparation of laboratory sheets from pulps with a high fines content. One procedure is applicable to the preparation of laboratory sheets using the conventional sheet former and the other using the Rapid-K'then sheet former. The sheets prepared prior to…

ISO 11085:2008 specifies procedures for the determination of the fat content of cereals, cereal-based products and animal feeding stuffs. These procedures are not applicable to oilseeds and oleaginous fruits. The choice of procedure to be used depends on the nature and composition of the material analysed and the reason for carrying out the analysis. Procedure A is a method for the determination…

This CSA Standard is based on ASTM D 1970-01. 1. Scope 1.1 This specification covers polymer modified bituminous sheet materials intended for use as underlayment on roof eaves, or valleys, or both, to prevent leakage of shingle, tile, or metal roofs from water back-up due to ice dams. 1.2 These underlayment sheets have a sticky adhesive layer which is exposed by removal of a protective…

ISO 9588:2007 specifies procedures for reducing susceptibility, or degree of susceptibility, to hydrogen embrittlement that can arise in surface finishing processes. The heat-treatment procedures for iron or steel specified in ISO 9588:2007 have been shown to be effective in reducing the susceptibility to hydrogen embrittlement. These heat-treatment procedures are used after surface finishing,…

This National Standard of Canada is based on International Standard IEC/TR 61400-24:2002. 1 Scope During the last few years, all major wind turbine manufacturers have made dedicated efforts towards developing adequate lightning protection systems, and the first experiences with these new designs are beginning to be seen. It is therefore reasonable at this time to consider and prepare for a…