Rechercher

ISO/IEC 20113:2004 specifies supplementary service Make Call Request (SS-MCR), which is related, but not limited to, various basic services supported by Private Integrated Services Networks (PISNs). Basic services are specified in ISO/IEC 11574. The supplementary service MCR enables a Requesting User to request a Co-operating User to establish a new Requested Call to a Destination User. This new…

ISO/IEC 20114:2004 specifies the signalling protocol for the support of the Make Call Request supplementary service (SS-MCR) at the Q reference point between Private Integrated services Network eXchanges (PINXs) connected together within a Private Integrated Services Network (PISN). Supplementary service MCR enables a Requesting User to request a Co-operating User to establish a new Requested…

ISO/IEC 20115:2004 specifies the combination of base standards, together with the selection of appropriate options and parameter values, necessary to specify how QSIG/PSS1 can be used for Message Centre Access (MCA) procedures. ISO/IEC 20115:2004 identifies the necessary or optional employment of particular functions, procedures and services for a Calling User to deposit messages for a Served…

ISO/IEC 20116:2004 specifies supplementary service Message Centre Monitoring/Mailbox Identification (SS-MCM/MID), which is related, but not limited, to various basic services supported by Private Integrated Services Networks (PISNs). Basic services are specified in ISO/IEC 11574. The supplementary service MCM enables a Served User to get informed by a Message Centre about the status and status…

ISO/IEC 20117:2004 specifies the signalling protocol for the support of the Message Centre Monitoring supplementary service (SS-MCM) as well as the Mailbox Identification supplementary service (SS-MID) at the Q reference point between Private Integrated services Network eXchanges (PINXs) connected together within a Private Integrated Services Network (PISN). The supplementary service MCM enables…

ISO 15000-2:2004 addresses the requirements for an ebXML message service handler for the eBusiness community. ISO 15000-2:2004 defines a communications-protocol neutral method for exchanging electronic business messages and defines specific enveloping constructs supporting reliable, secure delivery of business information. ISO 15000-2:2004 includes a flexible enveloping technique permitting…

Provides standard inductance factors (AL) and their tolerances for Pot, RM, ETD, EE, EP, EL and low-profile ferrite cores. Is recommended for users and manufacturers.

Gives the requirements for two types of heat-shrinkable, flame retarded, fluid resistant, elastomer sleevings, with a nominal shrink ratio of 2:1 for use at temperatures up to 120 C. Type A: Standard wall thickness Type B: Thin wall thickness These sleevings are normally supplied with internal diameters up to 102 mm for the standard wall thickness and up to 51 mm for the thin wall thickness.The…

Gives the requirements for two types of extruded polyolefin, flame retarded, limited fire hazard sleeving. Type A: Thin wall - Internal diameter up to 30 mm Type B: Thick wall - Internal diameter up to 30 mm These sleevings are normally supplied in the following colours: black, red, green, blue, white and yellow. These sleevings are for use up to temperatures of 90 °C. Sizes or colours other than…

Gives the requirements for one type of heat-shrinkable, flame retarded, with a nominal shrink ratio 2:1, fluid resistant polyvinylidene fluoride sleeving for use at temperatures up to 175 C. This sleeving is normally supplied with an internal diameter up to 25,4 mm, and the standard colour is transparent. Sizes or colours other than those specifically listed in this standard may be available as…