Acoustics and vibration — Laboratory measurement of vibro-acoustic transfer properties of resilient ...
ISO 10846-5:2008 specifies a driving point method for determining the low-frequency transfer stiffness for translations of resilient supports, under a specified preload. The method concerns the laboratory measurement of vibrations and forces on the input side with the output side blocked, and is called the “driving point method”.
The stiffness resulting from measuring the input displacement (…
THIS STANDARD SUPERSEDES PART B45.1-02 of B45 SERIES-02.
1 Scope
1.1
This Standard covers vitreous and non-vitreous china plumbing fixtures and specifies requirements for materials, construction, performance, testing, and markings. This Standard#s performance requirements and test procedures apply to all types of water closets and urinals that discharge into gravity drainage systems in…
THIS STANDARD SUPERSEDES PART B45.4-02 of B45 SERIES-02.
1 Scope
1.1
This Standard covers plumbing fixtures made of stainless steel alloys and specifies requirements for materials, construction, performance, testing, and markings.
Note: The term #corrosion-resisting steel# is also applied to stainless steel.
1.2
This Standard covers the following plumbing fixtures:
(a) bathtubs;
(…
Paints and varnishes — Determination of release rate of biocides from antifouling paints — Part 4: D...
ISO 15181-4:2008 specifies the apparatus and analytical method for determining the amount of pyridine-triphenylborane (PTPB) that has been released from an antifouling paint into artificial seawater in accordance with the procedure given in ISO 15181‑1. It determines the PTPB concentration in the artificial seawater extract and gives the final calculation for the release rate of PTPB under the…
Safety requirements for electrical equipment for measurement, control and laboratory use - Part 031:...
IEC 61010-031:2008 applies to hand-held and hand-manipulated PROBE ASSEMBLIES of the types described below, and related accessories which are intended for professional, industrial process, and educational use. These PROBE ASSEMBLIES are for use in the interface between an electrical phenomenon and test or measurement equipment. They may be fixed to the equipment or be detachable accessories for…
Plastics — Guidance for the use of standard fire tests
ISO 10840:2008 covers the following aspects of fire testing of plastics materials and products:
selection of appropriate tests that reflect realistic end-use conditions;
grouping of the reaction-to-fire characteristics that any given test or tests can measure;
assessment of tests as to their relevance in areas such as material characterization, quality control, pre‑selection, end-product testing…
Pulps — Preparation of laboratory sheets for physical testing — Part 3: Conventional and Rapid-Köthe...
ISO 5269-3:2008 specifies two procedures for preparing a closed water system which is in retention equilibrium, to be used for the preparation of laboratory sheets from pulps with a high fines content. One procedure is applicable to the preparation of laboratory sheets using the conventional sheet former and the other using the Rapid-K'then sheet former. The sheets prepared prior to…
Protective clothing against heat and flame — Test method for complete garments — Prediction of burn ...
ISO 13506:2008 provides the general principles of a test method for evaluating the performance of complete garments or protective clothing ensembles in a flash fire or other short duration exposures. This test method characterizes the thermal protection provided by garments, based on the measurement of heat transfer to a full-size manikin exposed to a laboratory simulation of a fire with…