Conducting and dissipative rubbers, vulcanized or thermoplastic — Measurement of resistivity
ISO 1853:2011 specifies the requirements for the laboratory testing of the volume resistivity of specially prepared test pieces of vulcanized or thermoplastic rubber compounds rendered conducting or dissipative by the inclusion of carbon black or ionizable materials. The tests are suitable for materials with a resistivity of less than about 108 ohm metres.
Method 1 is the preferred method when…
Lasers and laser-related equipment — Determination of laser resistance of tracheal tubes — Part 1: T...
ISO 11990-1:2011 specifies a method of testing the continuous wave (cw) resistance of the shaft of a tracheal tube designed to resist ignition by a laser. It is not applicable to other components of the system, such as the inflation system and cuff, which are defined in ISO 11990-2:2010.
ISO 11990-1:2011 can be used to measure and describe the properties of materials, products or assemblies in…
Laboratory glass and plastics ware — Tubes for the measurement of the erythrocyte sedimentation rate...
ISO 13079:2011 specifies requirements for single-use and re-usable glass and plastics tubes for measuring the erythrocyte sedimentation rate (ESR) by the Westergren method, and for a support to hold tubes during the performance of the test. These so-called "Westergren tubes" are also sometimes designated as "Westergren pipettes". A procedure for measuring the erythrocyte…
Textile floor coverings — Determination of electrical resistance
ISO 10965:2011 describes a laboratory method for the determination of the electrical resistance of textile floor coverings. The method includes both horizontal and vertical measurements.
Fine ceramics (advanced ceramics, advanced technical ceramics) — Ultraviolet light source for testin...
ISO 10677:2011 describes an ultraviolet (UV) light source and specifies a method of measuring the radiation intensity which is used in testing the performance of semiconducting photocatalytic materials in a laboratory.
Methods of measurement of the suppression characteristics of passive EMC filtering devices
CISPR 17:2011 specifies methods to measure the radio interference suppression characteristics of passive EMC filtering devices used in power and signal lines, and in other circuits. The defined methods may also be applied to combinations of over-voltage protection devices and EMC filtering devices. The measurement method covers the frequency range from 9 kHz to several GHz depending on the device…
Hand-held portable power tools — Test methods for evaluation of vibration emission — Part 10: Percus...
ISO 28927-10:2011 specifies a laboratory method for measuring hand-transmitted vibration emission at the handles of hand-held power driven percussive machines with and without rotary action [portable rock drills, plug hole drills, rotary hammers, breakers (e.g. pavement breakers, concrete breakers or road breakers), riveting hammers, chipping hammers, pick hammers or similar]. It is a type-test…