Consumer audio/video equipment - Digital interface - Part 8:Transmission of ITU-R BT.601 style digit...
IEC 61883-8:2008+A1:2014 specifies a protocol for the transport of uncompressed or compressed video data in the 4:2:2 format of recommendation ITU-R BT.601 (including compatible extensions to this format for the higher and lower resolutions of other commonly used video resolutions) over high performance serial bus, as specified by IEEE Std 1394-1995 as amended by IEEE Std 1394a-2000 and IEEE Std…
Fire hazard testing - Part 2-12: Glowing/hot-wire based test methods- Glow-wire flammability index (...
IEC 60695-2-12:2010+A1:2014 specifies the details of the glow-wire test to be applied to test specimens of solid electrical insulating materials or other solid materials for flammability testing to determine the glow-wire flammability index (GWFI). GWFI is the highest temperature, determined during this standardized procedure, at which the tested material; does not ignite or, if it does,…
Fire hazard testing - Part 2-13: Glowing/hot-wire based test methods- Glow-wire ignition temperature...
IEC 60695-2-13:2010+A1:2014 specifies the details of the glow-wire test to be applied to test specimens of solid electrical insulating materials or other solid materials for ignitability testing to determine the glow-wire ignition temperature (GWIT). The GWIT is the temperature which is 25 K (or 30 K) higher than the maximum test temperature, determined during this standardized procedure, at…
Welding — Fusion-welded joints in steel, nickel, titanium and their alloys (beam welding excluded) —...
ISO 5817:2014 provides quality levels of imperfections in fusion-welded joints (except for beam welding) in all types of steel, nickel, titanium and their alloys. It applies to material thickness ≥ 0,5 mm. It covers fully penetrated butt welds and all fillet welds. Its principles can also be applied to partial-penetration butt welds.(Quality levels for beam welded joints in steel are presented in…
Filler metals and allied materials for metal arc welding
Scope
1.1
This Standard specifies requirements for the classification and certification of
a) carbon steel covered electrodes for shielded metal arc welding (SMAW);
b) chromium and chromium-nickel steel covered electrodes for SMAW, including electrodes designated for welding heat-resistant steels containing more than 11% chromium and less than 50% nickel;
c) low alloy steel covered…
ISO 25841:2014 specifies the minimum requirements and test methods for female condoms, which are supplied to consumers for contraceptive purposes, assisting in the prevention of sexually transmitted infections.
1 Scope
1.1
[Replace this clause with the following]
This Standard contains technical requirements and practices including test methods applicable to the
design, manufacture/construction, installation, and labelling of corded window covering products. The
requirements provided in this Standard are intended to minimize the hazards posed to young children by
corded window covering products.…