Rechercher

1.1 This Standard applies to wall and ceiling-mounted track lighting systems, rated 347 V, 40 A max, incorporating incandescent, fluorescent, light emitting diodes and high-intensity discharge lighting sources, intended to be installed in non-hazardous, dry locations in accordance with the Canadian Electrical Code, Part I. 1.2 This Standard applies to plug- and cord-connected track lighting…

IEC 61935-1:2015(E) specifies reference measurement procedures for cabling parameters and the requirements for field tester accuracy to measure cabling parameters identified in ISO/IEC 11801. References in this standard to ISO/IEC 11801 mean ISO/IEC 11801 or equivalent cabling standards. This International Standard applies when the cable assemblies are constructed of cables complying with the IEC…

IEC TS 62257-6:2015(E) describes the various rules to be applied for acceptance, operation, maintenance and replacement of decentralized rural electrification systems which are designed to supply electric power for sites which are not connected to a large interconnected system, or a national grid, in order to meet basic needs. This technical specification proposes a methodology to achieve the…

IEC TS 62257-5:2015(E) specifies the general requirements for the protection of persons and equipment against electrical hazards to be applied in decentralised rural electrification systems. Requirements dealing with protection against electric shock are based on basic rules from IEC 61140 and IEC 60364. Decentralized Rural Electrification Systems are designed to supply electric power for sites…

IEC 62153-4-7:2015 describes a triaxial method, suitable to determine the surface transfer impedance and/or screening attenuation and coupling attenuation of mated screened connectors (including the connection between cable and connector) and cable assemblies. This method could also be extended to determine the transfer impedance, coupling or screening attenuation of balanced or multipin…

IEC 62153-4-7:2015 describes a triaxial method, suitable to determine the surface transfer impedance and/or screening attenuation and coupling attenuation of mated screened connectors (including the connection between cable and connector) and cable assemblies. This method could also be extended to determine the transfer impedance, coupling or screening attenuation of balanced or multipin…

ISO 18563-3:2015 concerne l'appareillage d'essais par ultrasons équipé de traducteurs linéaires multiéléments, en contact (avec ou sans sabot) ou en immersion, avec des fréquences centrales comprises entre 0,5 MHz et 10 MHz. Elle décrit les méthodes et les critères d'acceptation applicables à la vérification des performances de l'équipement complet (à savoir appareil,…

ISO 18563-3:2015 addresses ultrasonic test systems implementing linear phased array probes, in contact (with or without wedge) or in immersion, with centre frequencies in the range of 0,5 MHz?10 MHz. It provides methods and acceptance criteria for verifying the performance of combined equipment (i.e. instrument, probe and cables connected). The methods described are suitable for users working…

ISO 18246 :2015 spécifie les exigences de sécurité relatives au couplage conductif des cyclomoteurs et motocycles à propulsion électrique à une borne d'alimentation électrique externe. ISO 18246 :2015 ne s'applique pas aux véhicules qui ne sont pas dans des conditions normales, tels que des véhicules endommagés et des véhicules présentant une défaillance mécanique et/ou électrique. ISO…

ISO 18246:2015 specifies safety requirements for conductive connection to an external electric power supply of electrically propelled mopeds and motorcycles. It is not applicable to vehicles not in normal conditions, such as damaged vehicles and vehicles which have mechanical and/or electrical failure. It applies only to on-board charging systems between the plug or vehicle couplers and RESS…