Rechercher

ISO 28278-1:2011 specifies requirements for the suitability of supported and unsupported glass products for use in the structural sealant glazing (SSG) technique. Regarding glass products, ISO 28278-1:2011 constitutes a supplement to the requirements specified in the corresponding international standards with regard to verifying suitability for use in SSG systems. Only soda lime silicate glass is…

ISO 12830:2011 specifies the procedure for the determination of acid-soluble magnesium, calcium, manganese, iron, copper, sodium and potassium by atomic absorption spectrometry or by plasma emission spectrometry. The acid-soluble element comprises the acid-soluble part of the incineration residue, i.e. that part of the ignition residue obtained after incineration which is soluble in hydrochloric…

ISO 28017:2011 specifies requirements for two types, seven classes and three grades of wire- or textile-reinforced dredging hoses with nominal sizes ranging from 100 to 1 200. Within each class, all grades and sizes have the same maximum working pressure. Such hoses are suitable for the delivery or suction of seawater or freshwater mixed with silt, sand, coral and small stones with a specific…

ISO 30300:2011 defines terms and definitions applicable to the standards on management systems for records (MSR) prepared by ISO/TC 46/SC 11. It also establishes the objectives for using a MSR, provides principles for a MSR, describes a process approach and specifies roles for top management. ISO 30300:2011 is applicable to any type of organization that wishes to: · establish, implement…

ISO 22432:2011 defines general terms and types of features for geometrical features of specifications for workpieces. These definitions are based on concepts developed in ISO/TS 17450-1. ISO 22432:2011 is not intended for industrial use as such among designers, but is aimed to serve as the "road map" mapping out the interrelationship between geometrical features, thus enabling future…

B64.0-11 - Definitions, general requirements, and test methods for vacuum breakers and backflow preventers 1 Scope 1.1 The CSA B64 Series covers vacuum breakers and backflow preventers that are used in potable water supply systems to prevent cross-connections. 1.2 This Standard specifies definitions, general requirements, test methods, markings, and instructions that are common to…

1 Scope 1.1 This Standard describes the design, construction, load rating, installation, erection, inspection, maintenance, repair, modification, test, and operation of lattice and telescopic boom mobile cranes. Note: See Annex A for illustrations of mobile cranes and Annex B for illustrations of parts of a mobile crane. 1.2 This Standard applies only to machines that have all of the following…

ISO 4753:2011 specifies the form and dimensions of ends of parts with external ISO metric screw thread (e.g. bolt, screw and stud ends) recommended for use. They apply to standardized or non-standardized threaded parts. For each end type, a symbol is specified and it is intended that these symbols be used when specifying one of the ends for threaded fasteners.

ISO 2475:2011 specifies, for general-purpose chloroprene rubbers (CRs): physical and chemical tests on raw rubbers; standard materials, standard test formulations, equipment and processing methods for evaluating the vulcanization characteristics.

ISO/IEC 14776:2011(E) documents the commands and parameters necessary to manage and sense the state of the power supplies, cooling devices, displays, indicators, individual drives, and other non-SCSI elements installed in an enclosure. The command set uses the SCSI SEND DIAGNOSTIC and RECEIVE DIAGNOSTIC RESULTS command to obtain configuration information for the enclosure and to set and sense…