Rechercher

Applies to compression and mechanical connectors for power cables for rated voltages up to 30 kV (Um = 36 kV), e.g. buried cables or cables installed in buildings, having - conductors complying with IEC 60228 and IEC 60228A with cross-sectional areas 10 mm2 and greater for copper and 16 mm2 and greater for aluminium, - a maximum continuous conductor temperature not exceeding 90 °C. This standard…

IEC 60999-2:2003 Applies to screw-type and screwless-type clamping units for connecting devices, either as separate entities or as integral parts of equipment, for the connection of electrical copper conductors (complying with IEC 60228), rigid stranded and/or flexible, having a cross-section above 35 mm2 and up to and including 300 mm2 and equivalent AWG/kcmil sizes with a rated voltage not…

ISO/TR 7861:2002 presents injury risk curves that can be used for injury risk assessment in the evaluation of occupant protection in road-vehicle frontal impact. The measurements were made on frontal-impact crash test dummies which present acceptable levels of biofidelity response in accordance with ISO 12349-1 and ISO 12349-2 and which are used in the frontal-impact test procedures of existing…

ISO 19107:2003 specifies conceptual schemas for describing the spatial characteristics of geographic features, and a set of spatial operations consistent with these schemas. It treats vector geometry and topology up to three dimensions. It defines standard spatial operations for use in access, query, management, processing, and data exchange of geographic information for spatial (geometric and…

ISO 19115:2003 defines the schema required for describing geographic information and services. It provides information about the identification, the extent, the quality, the spatial and temporal schema, spatial reference, and distribution of digital geographic data. ISO 19115:2003 is applicable to: the cataloguing of datasets, clearinghouse activities, and the full description of datasets;…

ISO 8573-7:2003 specifies a test method for distinguishing viable, colony-forming, microbiological organisms (e.g. yeast, bacteria, endotoxins) from other solid particles which may be present in compressed air. One of a series of standards aimed at harmonizing air contamination measurements, it provides a means of sampling, incubating and determining the number of microbiological particles. The…

ISO 18613:2003 specifies the maximum defects and damage allowed before a flat wooden pallet shall be repaired, and defines the minimum repair criteria that shall be used. This European Standard is applicable to wooden flat pallets repaired with wood based components. NOTE The maximum allowed defects and damage for pallets are described in this standard and the annexes A to D show examples of…

1 Scope 1.1 This Standard describes general requirements, apparatus, and test methods to be used in carrying out applicable tests and calculations for rigid nonmetallic conduits, elbows, bends, and associated fittings required by the rigid nonmetallic conduit Standards of the Canadian Electrical Code, Part II. 1.2 The various types of rigid nonmetallic conduits are as follows: a) rigid…

1. SCOPE 1.1 Organization and Content - This standard sets out requirements for the design and manufacture of packaging used for the transportation of infectious substances, diagnostic specimens, biological products or (bio) medical waste. There are three categories of packaging: Type 1A (UN Standard Infectious Substance Packaging), Type 1B and Type 1C. UN Standard Infectious Substance Packaging…

1 Scope 1.1 This Standard provides requirements and recommended practices for the warehousing, storage, handling, and transportation of clean and sterile medical devices in facilities where open-inventory (?split-case?) storage and handling services are provided. Note: The storage facilities covered by this Standard include, but are not limited to, a) warehouses; b) storerooms; and c…