Rechercher

This standard describes the basic Canada Standard sizing system for determining the body size of boys' and girls'. It outlines the development of the system and provides in tabular form body measurements in metric units for standard size ranges covering practically all male and female members of the population from about two to three years of age until they reach their middle to upper…

1. DEFINITION 1.1 This standard applies to desk trays manufactured from plastic, and metal support sets for stacking the trays.

1. Scope 1.1 This Standard applies to heat pump water heaters and refrigerant desuperheaters rated at 600 V or less, designed to be installed indoors in accordance with the Rules of the Canadian Electrical Code, Part I, and the applicable local Plumbing Code. 1.2 This Standard applies to packaged heat pump water heaters (which hereinafter may be referred to as "equipment")…

1. Scope 1.1 This Standard applies to voltage and polarity testers for use in nonhazardous locations, in accordance with the Rules of the Canadian Electrical Code, Part I, on electrical supply circuits and equipment at points where the voltage difference does not exceed 750 V. 1.2 This Standard does not apply to a device primarily intended to measure voltage, such as one that employs a…

Applies to testing agencies that are engaged in the testing of piping systems for nonflammable medical gases to determine their conformity to Part III of Standard Z305.1

Specification of a method for determining the apparent viscosity, at high shear, of polyvinylchloride pastes prepared from polyvinylchloride polymers and plasticizers. It applies in particular to "standard pastes" according ISO 4612. Placing of a sample in a Severs rheometer and setting of the jacket to a defined temperature. Measurement of the flow rate of the paste through a…

The ISO bibliographic filing rules are an implementation of ISO 7154, reflecting the filing practices of a substantial number of national filing rules. Selects from ISO 7154 the principles that apply to a four-level hierarchy consisting of (from highest to lowest) - filing entry; - filing area; - filing section; - filing character.

1. Scope 1.1 General 1.1.1 This Standard specifies minimum requirements for a suppli er's quality assurance program - Category 1. The supplier is responsible for planning and developing a program which assures that each management, design, and technical responsibility for quality is integrated and executed effectively. The program is aimed primarily at being preventive by…

1. Scope 1.1 General 1.1.1 This Standard specifies minimum requirements for a s upplier's quality assurance program - Category 2. The supplier is responsible for planning and developing a program aimed primarily at controlling production processes as well as inspection and test verifications and corrective action which (a) assure that products or services conform to specified…

1. Scope 1.1 General 1.1.1 This Standard specifies minimum requirements for a supplier's Quality Assurance Program - Category 3. The supplier is responsible for planning and developing a program aimed primarily at controlling inspection and test verifications which (a) assure that products or services conform to specified requirements; and (b) readily detect and control the…