Rechercher

This International Standard specifies the signalling protocol for the support of the Call Identification and Call Linkage Additional Network Feature (ANF-CIDL) at the Q reference point between Private Integrated Network Services Exchanges (PINXs) connected together within a Private Integrated Services Network (PISN). ANF-CIDL is an additional network feature which allows the assignment of a…

This National Standard of Canada is based on International Standard IEC 60335-2-36:2000 (fourth edition, 2000-02). 1. Scope This clause of part 1 is replaced by: This standard deals with the safety of electrically operated commercial cooking ranges, ovens, hobs, hob elements and similar appliances not intended for household use, their rated voltage being not more than 250 V for…

This National Standard of Canada is based on International Standard IEC 60335-2-42:2000 (fourth edition, 2000-03) 1. Scope This clause of part 1 is replaced by: This standard deals with the safety of electrically operated commercial forced convection ovens, steam cookers, steam-convection ovens and, exclusive of any other use, steam generators, not intended for household use, their rated…

This National Standard of Canada is equivalent to International Standard ISO/IEC 15052:1997 (first edition, 1997-05-15). 1 Scope This International Standard specifies the signalling protocol for the support of Recall supplementary service (SS-RE) at the Q reference point between Private Integrated Services Network Exchanges (PINXs) connected together within Private Integrated Services…

This CSA Standard is a Harminized Standard with ANSI Z21.75-2001. Part I: Construction 1.1 Scope 1.1.1 This standard applies to newly produced assembled connectors constructed entirely of new, unused parts and materials. Such connectors are intended for exterior use above ground for making the following nonrigid connections: a. Between the gas supply and the gas…

This National Standard of Canada is equivalent to International Standard ISO/IECISP 12062-3:1997. 1 Scope 1.1 General This part of ISO/IEC ISP 12062 covers message transfer between Message Transfer Agents (MTAs) in an Interpersonal Messaging (IPM) environment using the P1 Message Transfer Protocol (see also figure 1). These specifications form part of the Interpersonal Messaging application…

La présente partie de l'ISO 15171 spécifie les dimensions, les exigences de performance et les modes opératoires d'essai pour un raccord pour utilisation à des fins de diagnostic, avec une extrémité mâle droite M14 x 1,5 pour accouplement avec un orifice ISO 6149-1 et un embout de raccord M16 x 2, et qui peut être connecté sous pression sans outil jusqu'à une pression maximale de…

1. Scope 1.1 Purpose The purpose of this Code is to provide minimum requirements for the design, construction, installation, and maintenance of those mechanical refrigeration systems included in Clause 1.2, so as to minimize the risk of human injury. Note: This Code does not directly address protection of property and preservation of the environment, which may be addressed in other Acts…

Object The object of this Code is to establish safety standards for the installation and maintenance of electrical equipment. In its preparation, consideration has been given to the prevention of fire and shock hazards, as well as proper maintenance and operation. Compliance with the requirements of this Code and proper maintenance will ensure an essentially safe installation.…

S'applique aux matériels comme les récepteurs de radiodiffusion sonore et visuelle, les amplificateurs, les transducteurs de charge et de source et ses appareils à entraînement par moteur (radio-électrophones, magnétophones et projecteurs de films sonores) qui doivent être raccordés au réseau directement ou indirectement et qui sont destinés à des usages domestiques en intérieur ou à des…