Rechercher

lEC 60320-3:2014 sets the dimensions for appliance couplers for two poles and two poles with earth contact: - for the connection of electrical devices for household and similar onto the mains supply and - for the interconnection of the electrical supply to appliance or equipment - and dimensions for gauges. This publication is to be read in conjunction with IEC 60320-1:2007.

IEC 61169-48:2014, which is a sectional specification (SS), provides information and rules for the preparation of detail specifications (DS) for series BMP RF coaxial connectors with blind mating, typically for use in 50 Ohms board to board connection. They may also be used with RF cables or micro-strips in microwave, telecommunication, wireless and other fields. Their operating frequency limit…

1 Scope 1.1 This standard applies to quick-connect terminals, both connectors and tabs, having nominal widths of 2.8, 3.2, 4.8, 5.2, and 6.3 mm (0.110, 0.125, 0.187, 0.205, and 0.250 in). They are intended for internal wiring connections in electrical equipment and for the field termination of conductors to electrical equipment in accordance with Part I of the Canadian Electrical Code, C22.1…

Canadian deviations International Standard IEC 60384-14:2013 (fourth edition) forms the basis for CAN/CSA-E60384-14, which contains the following deviations in addition to those shown in CAN/CSA-E60384-1:14. [Replace all references to “IEC 60384-1” with “CAN/CSA-E60384-1”] 1 General 1.1 Scope [Add the following] This Standard covers the above-noted products that are intended to be…

1 Scope 1.1 This Standard applies to portable type gas water heaters (herein after referred to as appliance or water heater) for use with propane, butane, or liquefied petroleum gases and mixtures thereof having: a) a regulated pressure; b) a non-regulated pressure. 1.2 Portable type water heaters and components employing materials or having forms of construction differing from those…

1 Scope This International Standard gives requirements for the Performance and safety of stand-alone gas mixers intended for medical use and intended for connection to a medical gas supply System. Rationales for some of the requirements are given in annex B. This International Standard does not apply to a) blocks of flowmeters with separate controls for the flow of each gas; b) gas mixers…

1 SCOPE 1.1 Except as described in Clause 1.7, these minimum requirements cover single and double wall cylindrical steel, non-pressure tanks of the horizontal type that are used for the underground storage of flammable liquids and combustible liquids, that are compatible with the material of construction. 1.2 These minimum requirements cover double wall tanks with provision for leak detection…

1 SCOPE 1.1 This Standard provides minimum requirements for primary containment leak detection that uses quantitative assessment of physical characteristics to detect leaks in the primary containment. 1.2 These requirements do not cover qualitative nonvolumetric leak detection devices. 1.3 The requirements of this Standard apply to newly-manufactured products. The requirements of this…

1 DOMAINE D’APPLICATION 1.1 La présente norme comprend les exigences minimales relatives à la détection des fuites dans une enceinte de confinement primaire. Cette détection s’appuie sur une évaluation quantitative des caractéristiques physiques. 1.2 Ces exigences ne touchent pas les dispositifs de détection des fuites non volumétriques qualitatives. 1.3 Les exigences de la présente norme s’…

1 SCOPE 1.1 This Standard provides minimum requirements for primary containment leak detection that uses qualitative characteristics to detect leaks in the primary containment. NOTE: Depending on the design of the tank system, and the capabilities of the leak detection devices, leaks from the tank alone, and/or from other parts of the tank system, may be detected. 1.2 Nonvolumetric leak…