Road vehicles — FlexRay communications system — Part 4: Electrical physical layer specification
ISO 17458-4:2013 specifies the electrical physical layer for FlexRay communications systems.
The electrical physical layer for FlexRay is designed for time-triggered networks with data-rates up to 10 Mbit/s to connect automotive electronic control units (ECUs). The medium that is used is dual wires. Signalling on the bus is accomplished by asserting a differential voltage between those wires.…
Road vehicles — Calculation processes for the neck injury criteria in rear impact
ISO/TR 13330:2013 recommends calculation procedures for several neck performance criteria for low-severity rear impact that are found in the literature. ISO/TR 13330:2013 does not recommend any particular criteria or provide injury risk curves since the mechanisms of whiplash injury are neither proven nor validated. Calculations given in ISO/TR 13330:2013 apply to mid-size adult male dummies only.
Road vehicles — Traffic accident analysis — Part 3: Guidelines for the interpretation of recorded cr...
ISO/TR 12353-3:2013 describes the determination of impact severity in road vehicle accidents as defined in ISO 12353-2, based on recorded acceleration and velocity data and derived parameters from vehicle crash pulse recorders or event data recorders, including data from self-contained devices or vehicle integrated functionalities.
Hybrid-electric road vehicles — Exhaust emissions and fuel consumption measurements — Part 1: Non-ex...
ISO 23274-1:2013 specifies a chassis dynamometer test procedure to measure the exhaust emissions and the electric energy and fuel consumption for the vehicles.
It applies to vehicles with the following characteristics:
the vehicle is classified as passenger cars or light duty trucks, as defined in each regional annex;
the nominal energy of the rechargeable energy storage system (RESS) is at…
Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part ...
ISO 16750-3:2012 applies to electric and electronic systems/components for road vehicles. It describes the potential environmental stresses and specifies tests and requirements recommended for the specific mounting location on/in the vehicle.
ISO 16750-3:2012 describes mechanical loads.
Road vehicles — Test procedures for evaluating out-of-position vehicle occupant interactions with de...
ISO/TR 14933:2012 outlines test procedures for evaluating the effects of the interactions between deploying side air bags (SAB) and vehicle occupants.
ISO/TR 14933:2012 describes dummies, procedures, instrumentation and test configurations that can be used for investigating the interactions that occur between a deploying side air bag and a vehicle occupant in front and rear seats.
Electric traction - Rotating electrical machines for rail and road vehicles - Part 4: Permanent magn...
IEC 60349-4:2012 applies to converter-fed permanent magnet synchronous motors or generators (machines) forming part of the equipment of electrically propelled rail and road vehicles. The object of this part is to enable the performance of a machine to be confirmed by tests and to provide a basis for assessment of its suitability for a specified duty and for compa-rison with other machines.…
