Rechercher

IEC 60913:2024 specifies the requirements and tests for the design of overhead contact line systems, requirements for structures and their structural calculations and verifications as well as the requirements and tests for the design of assemblies and individual parts. This document is applicable to electric traction overhead contact line systems in heavy railways, light railways, for trolley bus…

This document specifies a transport and network layer protocol with transport and network layer services tailored to meet the requirements of CAN-based vehicle network systems on controller area networks as specified in ISO 11898-1. The diagnostic communication over controller area network (DoCAN) protocol supports the standardized abstract service primitive interface as specified in ISO 14229-2…

This document provides information and specifications on the management of road traffic in controlled zones (CZ) through the application of geofencing. Specifically, this document specifies a “Controlled Zone Data Dictionary” (CZDD) for management of controlled zones, and provides an extendible toolkit that regulators can use, for example, to inform potential CZ users (e.g. vehicles) about…

This document specifies a freight vehicle safety information provisioning service application or function. It is intended for use within non-enforcement applications and potentially for regulated application services (RAS), for the road transport safety management purposes of regulated commercial freight vehicle movements. This document reinforces vehicle safety for non-enforcement purposes and…

IEC 62752:2024 This International Standard applies to in-cable control and protection devices (IC-CPDs) for mode 2 charging of electric road vehicles, hereafter referred to as "IC-CPD", including control and safety functions. This document applies to portable devices performing simultaneously the functions of detection of the residual current, of comparison of the value of this current…

This document represents an open international standard for information used in Building Information Modeling (BIM) that is exchanged and shared among software applications used by the various participants in the construction or facility management industry sector. This document includes definitions that cover information required for buildings and infrastructure works over their life cycle. This…

This document specifies physical medium attachment (PMA) sublayers for the controller area network (CAN). This includes the high-speed (HS) PMA without and with low-power mode capability, without and with selective wake-up functionality. Additionally, this document specifies PMAs supporting the signal improvement capability (SIC) mode and the FAST mode in Annex A. The physical medium dependent (…

This document specifies the technical requirements to minimise the hazards listed in Clause 4 which can arise during the commissioning, operation and maintenance of container/pallet dollies and loose load trailers when carried out in accordance with the specifications given by the manufacturer or his authorised representative. It also takes into account some performance requirements recognised as…

1 Scope 1.1 General This Standard specifies the mechanical, electrical, and safety requirements for newly designed and manufactured compact hydrogen fuelling systems (cHFS) and similar integral hydrogen generation, compression, storage, and dispensing systems intended to fuel on- or off-road hydrogen motor vehicles equipped with onboard fuel containers that are compliant with SAE J2579 or UN…

This document specifies requirements for short-range communication for the purposes of compliance checking in autonomous electronic fee collecting systems. Compliance checking communication (CCC) takes place between a road vehicle's on-board equipment (OBE) and an interrogator [fixed and mobile roadside equipment (RSE) or hand-held unit] and serves to establish whether the data that are…