Rechercher

1 Scope 1.1 This Standard applies to unvented portable type gas camp heaters of the catalytic and infrared type only up to and including a maximum input of 12,000 Btu/hr (3 517 w) using propane, butane, and liquefied petroleum gas mixtures thereof, and intended for outdoor use. 1.2 This Standard applies to portable type gas camp heaters having a: a) regulated pressure; or b) non-regulated…

1 Scope 1.1 This Standard covers cast iron soil pipe, fittings, and means of joining for installation in gravity-flow plumbing systems inside and outside of buildings, above and below grade. Note: Pipe and fittings that comply with this Standard are not universally compatible with pipe and fittings manufactured in accordance with ASTM A74 and ASTM A888. 1.2 In CSA standards, “shall” is…

1 Scope 1.1 General This Standard provides criteria in accordance with the National Building Code of Canada, for the structural design and evaluation of structures or structural elements made from wood or wood products, including: a) graded lumber; b) glued-laminated timber; c) cross-laminated timber (CLT); d) unsanded plywood; e) oriented strand board (OSB); f) composite building…

1 Scope and application 1.1 General This Standard provides rules and requirements for the design, fabrication, and erection of a broad range of steel structures based on limit states design approach. The term “steel structures” refers to structural members and frames that consist primarily of structural steel components, including structural steel acting compositely with concrete, and…

This method determines the dimensional change of fabrics or garments, likely to occur in domestic laundering. A fabric specimen or garment is subjected to an appropriate combination of specified washing, drying and restoration procedures. This method contains six washing, five drying and one restoration procedure as listed below: Washing procedures 1 - 30 °C, low mechanical action, synthetic…

This document provides test methods in support of the operation for cleanrooms and clean zones to meet air cleanliness classification, other cleanliness attributes and related controlled conditions. Performance tests are specified for two types of cleanrooms and clean zones: those with unidirectional airflow and those with non-unidirectional airflow, in three possible occupancy states: as-built,…

IEC 61747-30-3:2019(E) applies to transmissive type active matrix liquid crystal displays. This document defines general procedures for quality evaluation related to the motion performance of transmissive thin film transistor (TFT) LCDs. It defines artefacts in the moving image and methods for motion artefact measurement. NOTE Motion blur measurement methods and analysis methods introduced in…

IEC 60684-3-280:2019 RLV contains both the official IEC International Standard and its Redline version. The Redline version is available in English only and provides you with a quick and easy way to compare all the changes between the official IEC Standard and its previous edition. IEC 69684-3-280:2019 gives the requirements for heat-shrinkable, polyolefin sleeving, anti-tracking with a…

IEC 60684-3-283:2019 RLV contains both the official IEC International Standard and its Redline version. The Redline version is available in English only and provides you with a quick and easy way to compare all the changes between the official IEC Standard and its previous edition. IEC 60684-3-283:2019 gives the requirements for two types of heat-shrinkable, polyolefin sleeving for bus-bar…

IEC 69684-3-280:2019 gives the requirements for heat-shrinkable, polyolefin sleeving, anti-tracking with a nominal shrink ratio of 3:1. This sleeving has been found suitable for use at temperatures up to 100 °C. Typically: medium wall, internal diameter up to 110 mm. This sleeving is normally supplied in the colours red or brown. Since these types of sleeving cover a significantly large range of…