Rechercher

Scope 1.1 Facilities This Guideline and the CDG are intended to apply primarily to CANDU nuclear power stations in Canada. However, the radionuclides and environmental pathways addressed make this Guideline applicable to releases from many other nuclear facilities, including research reactors, radioisotope processing facilities, waste processing facilities such as incinerators, and power…

Scope 1.1 This Standard provides basic procedures based on joint ultimate load or a limiting slip for the determination of the lateral strength resistance and lateral slip resistance of truss plate teeth embedded in sawn and structural composite lumber members. 1.2 This Standard provides for the determination of the lateral strength resistance and lateral slip resistance of nails embedded…

Scope 1.1 This Standard applies to the selection of materials for, and the fabrication and installation of, preserved wood foundations. 1.2 Specific details are provided for buildings up to three storeys in building height above the foundation and having a building area not exceeding 600 m2. 1.3 This Standard provides for the optional use of wood sleeper, poured concrete slab, and suspended…

Scope 1.1 This Standard applies to natural and propane gas piping systems using corrugated stainless steel tubing (CSST), intended for installation in residential, commercial or industrial buildings, and including the following components as a minimum: a) Corrugated stainless steel tubing (CSST); b) Fittings for connection to the CSST; and c) Striker plates (see Clause 3, Definitions) to…

Scope 1.1 This Standard applies to single- and multi-conductor Type TECK 90 armoured cable intended for installation in accordance with the Canadian Electrical Code, Part I, on systems having nominal voltages of 5000 V and less and having a maximum temperature rating of 90 °C in both dry and wet locations. 1.2 In this Standard, "shall" is used to express a requirement, i.e., a…

Scope 1.1 This Standard applies to photovoltaic connectors: a) single pole, rated maximum 2000 V dc; and b) multi-pole, rated maximum 2000 V ac or dc. 1.2 This Standard applies to photovoltaic connectors intended for use in solar photovoltaic systems in accordance with the Canadian Electrical Code, Part I, using stranded copper conductors, for use in either indoor or outdoor nonhazardous…

Scope 1.1 These requirements cover bare and covered ferrules intended for field wiring and factory wiring for use in accordance with the National Electrical Code, ANSI/NFPA-70 and Canadian Electrical Code, CSA C22.1. 1.2 These ferrules are intended to facilitate the connection of stranded wire on to devices, such as terminal blocks. Their purpose is to treat stripped wire and prevent…

Scope 1.1 This Standard applies to deadfront indoor enclosed and outdoor enclosed assemblies of switchgear devices such as a) switches; b) interrupting devices; c) air circuit breakers; d) power circuit breakers; and e) control, metering, protective, and regulating equipment with associated interconnections and supporting structures. 1.2 This Standard covers equipment with a nominal…

Scope 1.1 This Standard applies to splitters, having a current rating of 5000 A and less, intended for installation in nonhazardous locations in accordance with the Rules of the Canadian Electrical Code, Part I on systems having nominal voltages of 600 V and less. 1.2 General requirements applicable to this Standard are given in CAN/CSA-C22.2 No. 0. 1.3 In this Standard, "shall" is…

Scope and object This standard applies to controllers and starters, which may include a series mechanical switching device, intended to be connected to circuits, the rated voltage of which does not exceed 1 000 V a.c. This standard characterizes controllers and starters with and without bypass means. Controllers and starters dealt with in this standard are not normally designed to…